Marvel 60RD Anleitung zur Fehlerbehebung PDF herunterladen (Seite 6)

INSTALLING THE ANTI-TIP DEVICE

"V" notches

in bracket

"V" notches

in bracket

⁄8"

(55.6cm)

Side of cabinet line

Figure 7

Front of cabinet line

Rear of cabinet line

Rear Leveling leg

Screw

Step by step instructions for locating the po-

sition of the bracket:

1) Decide where you want to place the drawer refrigerator.

Slide it into place, being careful not to damage the oor,

leaving 1"(2.5cm) of clearance from the rear wall to allow

room for the anti-tip bracket.

2) Raise the rear leveling legs approximately

⁄4" (6.4mm) to

allow engagement with the anti-tip bracket. Level the unit

by adjusting all the leveling legs as required. Turning the

leveling leg counterclockwise will raise the unit and clock-

wise will lower the unit.

3) Make sure the refrigerator is in the desired location, then

mark on the oor the rear and side corner of the cabinet

where the anti-tip bracket will be installed. If the installation

does not allow marking the rear corner of the cabinet, then

make temporary lines on the oor marking the front corner

of the cabinet, excluding the door. Slide the refrigerator out

of the way. From the temporary line extend the sidewall line

back 21

⁄8 (55.6cm) as shown in Figure 7.

4) Align the anti-tip bracket to the marks on the oor so

the side of the bracket lines up with the side of the cabinet

mark, and the "V" notches on the anti-tip bracket line up

with the end of the 21

⁄8" (55.6cm) line (Rear of cabinet

line).

5) Fasten the anti-tip bracket to the oor using the supplied

screw. (See Figure 7).

6) Slide the cabinet back into position, making sure the rear

cabinet leveling leg slides under the anti-tip bracket engag-

ing the slot.

One of the rear cabinet leveling legs must be engaged

under an anti-tip bracket.

If oor mounting of the bracket is not possible call AGA

Marvel service at (800-223-3900) for optional wall mount

bracket part number 42245874. The wall mount bracket

requires 1

⁄8"(4.8cm)

behind the rear of the cabinet for mounting.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Marvel 60RD Anleitung zur Fehlerbehebung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Marvel 60RD